ENCAPSALL SUPER is a very tough, protective, urethane coating that is especially designed for industrial applications, including secondary containment areas, pipelines, valves and transfer pits. Fortified with micaceous iron oxide, ENCAPSALL SUPER cures to a rubber-like, waterproof, seamless membrane that possesses exceptional strength and elasticity.
- Can be used over metal, concrete, masonry, brick, rubber, asphalt, wood, tile and other surfaces
- Produces a fully adhered, seamless, high density, waterproofing membrane
- Resistant to attack from most industrial chemicals, gasoline, acids, alkalis, and detergents
- Protects metals against rust, corrosion and pitting
- Will not deteriorate from exposure to slime molds, bacteria or other microbiological entities
- Easy to apply directly out of the container by brush, roller or airless spray
- Remains flexible, tough and resilient at low temperatures
- Highly penetrative and wets-out the substrate effectively
- Rapidly develops high tensile strength and elongation characteristics
- May be modified with K-CATALYST for non-newtonian rheological enhancement
Can be used over stucco, mineral composites, fibreglass composites, insulation, non-porous stone and other surfaces.
All surfaces to be treated must be clean, dry and free of loose debris, oils, grease and any substance that would interfere with proper bond. A careful inspection of the surface should be made to detect any signs of damage or defects and all repairs should be completed before application of product. Porous surfaces and certain bituminous surfaces require a priming coat. Contact our Technical Department for details and primer recommendations.
ENCAPSALL SUPER may be applied straight from the pail using brush, roller, or spray technique after 2 minutes of slow power stirring. ENCAPSALL SUPER is applied in 2 coats at a thickness of 16 wet mils per coat. If it is necessary to exceed 16 wet mils per coat OZ CATALYST may be added to the ENCAPSALL SUPER. Tools may be cleaned after use with Xylene or Toluene.
Tools may be cleaned after use in any aromatic solvent.
To prevent chalking or discoloration of the surface Andek recommends an application of WEARCOAT 66 over the ENCAPSALL SUPER. Keep ENCAPSALL SUPER pails away from direct sunlight. This product is a moisture-curing urethane and is packaged in specially sealed and air excluded drums. If damaged, air and moisture vapor may enter and cause premature curing. Care should be taken to avoid creating part full containers.
Damaged ENCAPSALL SUPER may be recoated after thorough cleaning and light sanding.
Read the container label warning and Material Safety Data Sheet (MSDS) for important health and safety information prior to the use of this product.
Keep out of reach of children and pets.
For additional information, contact the Andek Technical Department.
Notice: The information presented herein is based on tests and data that Andek Corporation believes to be reliable. It is intended for use by technically qualified personnel at their own discretion and risk. Since conditions of handling and use are beyond our control, we make no warranties, express or implied, and assume no liability in connection with any use of this information. Nothing herein is to be construed as a license to operate or a recommendation to infringe any patent.